Royal Purple’s Royal Flush is a safe, effective and inexpensive product for cleaning sludge and varnish from equipment while in service.
Because Royal Flush is available in only two viscosities and is not a fully formulated oil, machine loads and oil viscosity requirements should be considered when deciding how best to use Royal Flush. Cleaning time and effectiveness will vary depending upon such factors as the cleanliness of the system, the oil temperature, degree of oil agitation, the amount of Royal Flush added to the system and the duration of cleaning. The mixing chart (available below) provides a guideline for pre-mixing Royal Flush 46 with Royal Flush 1000 to create a new ISO viscosity grade of Royal Flush to attain the ISO grade desired, whether it’s for mixing with an existing oil or as a total replacement of the existing oil.
Royal Flush can be used in three ways:
● Royal Flush can be added to an existing oil to clean varnish and sludge from equipment prior to draining the existing oil.
● Royal Flush can be used as a temporary oil fill to clean varnish and sludge from equipment before refilling with new Royal Purple oil.
● Royal Flush can be used as a temporary oil fill for cleaning and flushing a poly-glycol oil that is incompatible with the new oil to be used (i.e. when changing from a poly-glycol oil to a Royal Purple PAO or para-synthetic oil).
Flushing / cleaning procedures can vary depending on the type of equipment, the number and location of oil drain points, how dirty the system is, the quality of filtration and the ability to monitor and / or change filters / screens in circulating systems and other service parameters.
Royal Flush has some anti-wear properties, but it is not a full formulated oil. It can be used as a lubricant to clean and flush equipment in service for short periods of time. Whenever possible, it is recommended that Royal Flush be circulated throughout the oil system while the equipment is idle.
The Product Sheet contains general guidelines for system flushing / cleaning.
Unique Performance Advantages:
● Safe and Effective Flushing and Cleaning Fluid for Dirty Oil Circulating Systems and Reservoirs
● Effectively Flushes Poly-Glycol Synthetic Oils
● Cleans and Removes Existing Oxidized Oil and Sludge Deposits
● Can Be Used at 100 Percent Strength or Be Mixed with Existing Oils for Cleaning
● Can Be Used to Clean Equipment While in Service
● Has Low Volatility and High Flash Point
● Can Be Matched to Existing Oil Viscosity
● Cost Effective